Guest User!

You are not Sophos Staff.

Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 6 replies
  • Subscribers 2 subscribers
  • Views 11204 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Unable to re-install UTM 110/120 "no appliance hardware has been detected"

lorenzoboss
Hi,
after a Hard Disk failure, i replace the HD of a UTM 110/120, i'm trying to install a fresh image, but i'm getting "no appliance hardware has been detected".
Obviously i'm using the Hardware ISO image !
I tried to install it with the Software ISO image, installation finish fine, but after the reboot Ethernet interface doesn't work (no line goes up).

Thanks for help
Lorenzo


This thread was automatically locked due to age.
Parents
  • 0
    I've had the failure to recognize hard drive occur in the past. Was able to work around by using DBAN to wipe the replacement drive first.

    If you use the software image then the NICs are probably detected in reverse order (port labeled eth3 is actually eth0, etc.) search forums for details on how to resolve.
Reply
  • 0
    I've had the failure to recognize hard drive occur in the past. Was able to work around by using DBAN to wipe the replacement drive first.

    If you use the software image then the NICs are probably detected in reverse order (port labeled eth3 is actually eth0, etc.) search forums for details on how to resolve.
Children
No Data