This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

NIC Upgrade

Can I change NIC Hardware easily, or do I need to do Kernel module changes.

Example can I just power off the unit swap NIC's and power the unit back on, then just configure for the new NIC in the web interface or to I need to install the kernel modules for the new NIC.

This thread was automatically locked due to age.

Parents

0 Amodin over 10 years ago

Normally for the UTM to see the new NIC, you have to reinstall the UTM software.

XG 19.5 GA 64-bit | Intel Xeon 4-core v3 1225 3.20Ghz
16GB Memory | 500GB SSD HDD | GB Ethernet x5
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Amodin over 10 years ago

Normally for the UTM to see the new NIC, you have to reinstall the UTM software.

XG 19.5 GA 64-bit | Intel Xeon 4-core v3 1225 3.20Ghz
16GB Memory | 500GB SSD HDD | GB Ethernet x5
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

NIC Upgrade

Submitted a Tech Support Case lately from the Support Portal?