This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

USB nic devices working with UTM 9.3

Hi,

I tried the Trendnet TU2-ET100 but this device will not be configure while installing v9.306.

Any hints for USB adapters found running? Maybe adapters using RTL8152/3 chipset?

Thanks & all the best, Ralf

This thread was automatically locked due to age.

Parents

0 Scott_Klassen over 10 years ago

Installation of 3rd party software, including drivers, is unsupported with the UTM. UTM has a very limited number of drivers, so a device will either work or not. Given that this is on a laptop, it may make more sense to run the UTM in a hypervisor than on the bare-metal.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Scott_Klassen over 10 years ago

Installation of 3rd party software, including drivers, is unsupported with the UTM. UTM has a very limited number of drivers, so a device will either work or not. Given that this is on a laptop, it may make more sense to run the UTM in a hypervisor than on the bare-metal.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

USB nic devices working with UTM 9.3

Submitted a Tech Support Case lately from the Support Portal?