at our branachoffice's SG125 i configured via Webadmin some networkdefinitions and user and propably deleted a vpn certificate, but i'm not sure about it, after some confusion yesterday. But after a while i noticed, that the SG125 was unreachable from our HQ. I drove to that branchoffice and tried to connect directly via LAN to that box. But with no success, also directly to LAN-Nic connected.
- No PING to box possible
- No WAN / LAN connection
- No Webadmin access
- Unusual LED blinking (eth0 / eth1)*
* For example: Both LED for eth0 were normally acting and then they went off for ~ 10 sec. After that they turned on again and the eth1 LEDs starts with that magic failure after a while.
Only these interfaces are configured and connected.
I accessed the box via Serial-Cable and saw with a ifconfig, that the eth0 interface had the right settings.
So my question to you is:
Which logs i can view, to get an idea, what happend yesterday while i was configuring?
What does it mean, when the LEDs act like that?
I solved the problem, through a config restore via cli.
But i need the reason for that happening. [8-)]
PS: Attached, you see the changelog from webadmin. But there is nothing special, i find.
Thank you.
Christian
This thread was automatically locked due to age.
