This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cannot delete Ethernet Bridge in 9.3

Hi,

I'm running an UTM SW Appliance with 2 eth ports and want to convert back my bridge config to isolated interfaces. Via web gui this is not possible any more, i believe up to 9.2 this could be done while bridge config being a separate config item.
Any ideas without going for factory defaults?

Thanks,
Markus

This thread was automatically locked due to age.

Parents

0 DarkKnight93 over 10 years ago

ahhh sh*t I've ran in the same issue and lost all my Settings.
In 9.2 this was no issue at all [:(]
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 DarkKnight93 over 10 years ago

ahhh sh*t I've ran in the same issue and lost all my Settings.
In 9.2 this was no issue at all [:(]
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 lferrara over 10 years ago in reply to DarkKnight93

Hi all,

it is definitely a bug. Today I bought a usb ethernet card, reboot the utm and still cannot convert bridge to single eth selection. Same error.
The usb card (eth2) in my case is not selectable when I try to covert from bridge ethernet to ethernet, but if I create a new interface, the eth2 is available.

Someone from Sophos can have a look at?

I am thinking in cases where you have all your eth been used (utm 100/110/120 has 4 eth, for example) and you have to convert from bridge to nat mode, what do you do?

I am really really bad about 9.3
[:@][:@][:@]
Cancel
Vote Up 0 Vote Down

Cancel

Cannot delete Ethernet Bridge in 9.3

Submitted a Tech Support Case lately from the Support Portal?