This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cannot delete Ethernet Bridge in 9.3

Hi,

I'm running an UTM SW Appliance with 2 eth ports and want to convert back my bridge config to isolated interfaces. Via web gui this is not possible any more, i believe up to 9.2 this could be done while bridge config being a separate config item.
Any ideas without going for factory defaults?

Thanks,
Markus

This thread was automatically locked due to age.

Parents

0 twister5800 over 10 years ago

Hi,

I also created a bridge in mine UTM 9.3, and got the same error as yours - funny thing is that this error disappeared once, and got back after 9.308.

The fix for me was to do this:

1) Edit the bridge Interface
2) Deselect the interfaces that should no longer be part of the bridge, by removing the checkmarks in the window. - Leaving ex. the Internal interface as the ONLY one left with a checkmark.
3) In the dropdown box where you have "Ethernet Bridge" choose "Ethernet" and press OK.

Does that solve your issue?

-----

Best regards
Martin

Sophos XGS 2100 @ Home | Sophos v19 Architect
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 twister5800 over 10 years ago

Hi,

I also created a bridge in mine UTM 9.3, and got the same error as yours - funny thing is that this error disappeared once, and got back after 9.308.

The fix for me was to do this:

1) Edit the bridge Interface
2) Deselect the interfaces that should no longer be part of the bridge, by removing the checkmarks in the window. - Leaving ex. the Internal interface as the ONLY one left with a checkmark.
3) In the dropdown box where you have "Ethernet Bridge" choose "Ethernet" and press OK.

Does that solve your issue?

-----

Best regards
Martin

Sophos XGS 2100 @ Home | Sophos v19 Architect
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Cannot delete Ethernet Bridge in 9.3

Submitted a Tech Support Case lately from the Support Portal?