This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cannot delete Ethernet Bridge in 9.3

Hi,

I'm running an UTM SW Appliance with 2 eth ports and want to convert back my bridge config to isolated interfaces. Via web gui this is not possible any more, i believe up to 9.2 this could be done while bridge config being a separate config item.
Any ideas without going for factory defaults?

Thanks,
Markus

This thread was automatically locked due to age.

Parents

0 BAlfson over 10 years ago

You might need to reboot the UTM before trying the removal of the bridge, Luk. I don't think that should be necessary, but bridging has been upgraded recently, so there may be an issue.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel
0 lferrara over 10 years ago in reply to BAlfson

Thank you Balfson.

I have rebooted the UTM, of course, but no way. I am sure that exist a way to delete bridge from CC command, assign Internal network to eth0 and access Webadmin page to make these changes permarment.
This is very sad.....

[[[:(]]][[[:(]]][[[:(]]]
Cancel
Vote Up 0 Vote Down

Cancel
0 lferrara over 10 years ago in reply to lferrara

Also, see this attachment.

The UTM "allows" you to convert to convert the bridge to eth0 if you change the original bridge ip address to another one (it was 0.100 and now 0.10) in the same subnet but.... nothing happens. If I click on OK, the message appears again, and again....and again.

Can someone else reproduce this issue?
It can be a bug!!!

Luk
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 lferrara over 10 years ago in reply to lferrara

Also, see this attachment.

The UTM "allows" you to convert to convert the bridge to eth0 if you change the original bridge ip address to another one (it was 0.100 and now 0.10) in the same subnet but.... nothing happens. If I click on OK, the message appears again, and again....and again.

Can someone else reproduce this issue?
It can be a bug!!!

Luk
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Cannot delete Ethernet Bridge in 9.3

Submitted a Tech Support Case lately from the Support Portal?