This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cannot delete Ethernet Bridge in 9.3

Hi,

I'm running an UTM SW Appliance with 2 eth ports and want to convert back my bridge config to isolated interfaces. Via web gui this is not possible any more, i believe up to 9.2 this could be done while bridge config being a separate config item.
Any ideas without going for factory defaults?

Thanks,
Markus

This thread was automatically locked due to age.

Parents

0 BAlfson over 10 years ago

The easiest solution is to add another NIC that's an identical model to one of your existing NICs - that way, you won't have to re-install from ISO to get the driver loaded.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel
0 lferrara over 10 years ago in reply to BAlfson

Hi Balfson,

I deleted all the VLAN as you advise but I get the same error.

[:S][:S][:S]

I do not have other NICs available. It is a home utm with dual nic integrated on motherboard.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 lferrara over 10 years ago in reply to BAlfson

Hi Balfson,

I deleted all the VLAN as you advise but I get the same error.

[:S][:S][:S]

I do not have other NICs available. It is a home utm with dual nic integrated on motherboard.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Cannot delete Ethernet Bridge in 9.3

Submitted a Tech Support Case lately from the Support Portal?