Guest User!

You are not Sophos Staff.

Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 26 replies
  • Subscribers 2 subscribers
  • Views 14031 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cannot delete Ethernet Bridge in 9.3

stony4077
Hi,

I'm running an UTM SW Appliance with 2 eth ports and want to convert back my bridge config to isolated interfaces. Via web gui this is not possible any more, i believe up to 9.2 this could be done while bridge config being a separate config item.
Any ideas without going for factory defaults?

Thanks,
Markus


This thread was automatically locked due to age.
Parents
  • 0
    Hi, Markus and Micha, and welcome to the User BB!

    The "trick" is to edit the interface definition, uncheck the box for ethx, change the selection from "Ethernet bridge" to "Ethernet" and save.

    Cheers - Bob
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Reply
  • 0
    Hi, Markus and Micha, and welcome to the User BB!

    The "trick" is to edit the interface definition, uncheck the box for ethx, change the selection from "Ethernet bridge" to "Ethernet" and save.

    Cheers - Bob
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Children
  • 0 in reply to BAlfson
    Hi, Markus and Micha, and welcome to the User BB!

    The "trick" is to edit the interface definition, uncheck the box for ethx, change the selection from "Ethernet bridge" to "Ethernet" and save.

    Cheers - Bob


    Hi Bob,

    thanks for the hint and the nice welcome, but unfortunalty it is not working, don't know why.

    Here is the Error-Message:
    Das Bridge-Port-Objekt 'eth0 Intel Corporation I210 Gigabit Network Connection' ist für das Bridge-Objekt 'Internal Net (Bridged RED-LAN)' erforderlich.
    (Means: The Bridge-Port-Object (eth0) is for the Bridge-Object (Internal) required.)

    I tried it with only eth0 checked, also with no ethx checked, both produces the same message.
    I tried to edit the options of the interface object. Is this the right place? Seems to have some unresoleved depencies, but where?

    Thanks for the help D
    Mischa
Share Feedback
×

Submitted a Tech Support Case lately from the Support Portal?

Unfiltered HTML