This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cannot delete Ethernet Bridge in 9.3

Hi,

I'm running an UTM SW Appliance with 2 eth ports and want to convert back my bridge config to isolated interfaces. Via web gui this is not possible any more, i believe up to 9.2 this could be done while bridge config being a separate config item.
Any ideas without going for factory defaults?

Thanks,
Markus

This thread was automatically locked due to age.

Parents

0 Treffs_Lux over 10 years ago

Hi,

i have the same problem, fully configured FW (started with Firmware 7) with an Ethernet Bridge on eth0 and ethx.
Not possible to release the bridge without destroying the eth0-assosiations.
Factory Defaults is not an option for me, would mean at least some days for configuration.
Tried some Idea's, none to work 'till now. (New Dev created and in the bridge, then eth0 exclude etc etc).
We had the bridge on Internal Interface because of the RED Devices (i think in 7 we had to do so).

A pointer in the right direction would be nice, for both of us DD

Thanks to all
Micha
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Treffs_Lux over 10 years ago

Hi,

i have the same problem, fully configured FW (started with Firmware 7) with an Ethernet Bridge on eth0 and ethx.
Not possible to release the bridge without destroying the eth0-assosiations.
Factory Defaults is not an option for me, would mean at least some days for configuration.
Tried some Idea's, none to work 'till now. (New Dev created and in the bridge, then eth0 exclude etc etc).
We had the bridge on Internal Interface because of the RED Devices (i think in 7 we had to do so).

A pointer in the right direction would be nice, for both of us DD

Thanks to all
Micha
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Cannot delete Ethernet Bridge in 9.3

Submitted a Tech Support Case lately from the Support Portal?