This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Sophos UTM hot-Standby, 9.306 firmware applied on a 9.210-20 system

So i have Sophos SG 310 in Hot-Standy(Active-Passive), i was having an Email Protection issue with TLS in Firmware Version 9.210-20, and was informed that i could resolve it by applying 9.3 firmware. The firmware I found was 9.306, which turns out you are ALLOWED TO UPLOAD to the system, and also to begin an UP2DATE, but it fails to apply at all.

I now have a Hot-Standby system where the Node2 is stuck now in WORKER mode with Status:UP2DATE. I have tried rebooting, but am having no success. I am no good with the Shell Access. Does anyone know how to get that Node2 back into Normal mode, so i can restart the firmware process correctly in the order prescribed to get from 9.210-20 up to 9.306?

Thanks for anyones help here.

This thread was automatically locked due to age.

Parents

0 zwaedi_01 over 10 years ago

from 9.210-20 you can not apply direct 9.306.

just apply Version by Version:
u2d-sys-9.210020-304009.tgz.gpg
u2d-sys-9.304009-305004.tgz.gpg
u2d-sys-9.305004-306006.tgz.gpg

Go ahead and upload all of them in that order.
After you have uploaded all of them you might choose to install 9.306 and it will automatically install .304 and .305.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 zwaedi_01 over 10 years ago

from 9.210-20 you can not apply direct 9.306.

just apply Version by Version:
u2d-sys-9.210020-304009.tgz.gpg
u2d-sys-9.304009-305004.tgz.gpg
u2d-sys-9.305004-306006.tgz.gpg

Go ahead and upload all of them in that order.
After you have uploaded all of them you might choose to install 9.306 and it will automatically install .304 and .305.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Sophos UTM hot-Standby, 9.306 firmware applied on a 9.210-20 system

Submitted a Tech Support Case lately from the Support Portal?