This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

HA pair with only HA cable connected?

We have some small offices where we are deploying redundant pairs of SG115s. These offices typically have a small dumb switch with no VLAN capability.

If we just use the SG pair with nothing but the HA cable connected, will that be sufficient for the partner device to stay up to date (config and firmware updates) or do we need to have the partner device connected to the WAN as well?

The idea would be that if the primary device ever failed, onsite staff would simply shift the WAN and LAN connections from primary to spare...

This thread was automatically locked due to age.

Parents

0 Scott_Klassen over 10 years ago

Correct, the cabling must be the same on HA units. Get a switch to put between the 4G device and the UTMs, so you can connect both.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Scott_Klassen over 10 years ago

Correct, the cabling must be the same on HA units. Get a switch to put between the 4G device and the UTMs, so you can connect both.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

HA pair with only HA cable connected?

Submitted a Tech Support Case lately from the Support Portal?