This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Install failure

I'm trying to install the latest version on an HP Elite desktop. The system boots up from the CD and I get the BOOT: prompt. I press enter to install and then CD runs for a couple seconds and then nothing else happens. No messages, no activity, just a blinking cursor. Any advice on how to proceed would be greatly appreciated.

Thanks!

This thread was automatically locked due to age.

Parents

0 BarryG over 10 years ago

Right... restoring a backup should always be done on a machine with at least as many NICs.

If you have to, you can disable NICs in the old machine and take a new backup.

Barry
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BarryG over 10 years ago

Right... restoring a backup should always be done on a machine with at least as many NICs.

If you have to, you can disable NICs in the old machine and take a new backup.

Barry
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Install failure

Submitted a Tech Support Case lately from the Support Portal?