This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Install failure

I'm trying to install the latest version on an HP Elite desktop. The system boots up from the CD and I get the BOOT: prompt. I press enter to install and then CD runs for a couple seconds and then nothing else happens. No messages, no activity, just a blinking cursor. Any advice on how to proceed would be greatly appreciated.

Thanks!

This thread was automatically locked due to age.

Parents

0 tbannar over 10 years ago

Thanks once again Bob. The problem was on my old pc I had 3 nics. eth0(isp), eth1(inactive), eth2(internal). On the new firewall, I have eth0(isp) and eth1(internal) So, when I applied the config to the new firewall, eth1 was disabled because it was on the old firewall. doh!
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 tbannar over 10 years ago

Thanks once again Bob. The problem was on my old pc I had 3 nics. eth0(isp), eth1(inactive), eth2(internal). On the new firewall, I have eth0(isp) and eth1(internal) So, when I applied the config to the new firewall, eth1 was disabled because it was on the old firewall. doh!
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Install failure

Submitted a Tech Support Case lately from the Support Portal?