Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

System won't boot after install

I'm having a problem installing Sophos UTM ver. 9.200-11.1. Installation goes well, but when the system restarts, I get nothing but a blinking cursor. It appears that the boot loader cannot be found. Any ideas on how to resolve this issue would be greatly appreciated.


This thread was automatically locked due to age.
Parents
  • Like Barry said, usually caused by card readers or multiple hard drives in one system.  Although, you've added in the extra complexity of installing from USB which is unsupported unless it is a Sophos branded ASI stick with a Sophos appliance.  The supported means is to burn the ISO to a CD and use a CD/DVD drive connected via usb.

    You've not given much more information than "me too", making it difficult to give more granular advise.
    __________________
    ACE v8/SCA v9.3

    ...still have a v5 install disk in a box somewhere.

    http://xkcd.com
    http://www.tedgoff.com/mb
    http://www.projectcartoon.com/cartoon/1
Reply
  • Like Barry said, usually caused by card readers or multiple hard drives in one system.  Although, you've added in the extra complexity of installing from USB which is unsupported unless it is a Sophos branded ASI stick with a Sophos appliance.  The supported means is to burn the ISO to a CD and use a CD/DVD drive connected via usb.

    You've not given much more information than "me too", making it difficult to give more granular advise.
    __________________
    ACE v8/SCA v9.3

    ...still have a v5 install disk in a box somewhere.

    http://xkcd.com
    http://www.tedgoff.com/mb
    http://www.projectcartoon.com/cartoon/1
Children