Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 20 replies
  • Subscribers 2 subscribers
  • Views 5093 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ASG220 v5 after 9.108-23 update http and snort restarting 2 times per day

janisg
Anyone have similar problems ?  No config changes, no load changes...


This thread was automatically locked due to age.
Parents Reply Children
  • 0 in reply to bschultz
    I am having the same issue with an ASG425.  Memory usage was running around 30% before the firmware upgrade. Now, in about 18 hours it will go to 100%, swap will climb and CPU utilization will also hit 100%. Snort and HTTP proxy continue to restart
  • 0 in reply to bbryant_sma
    I am having the same issue with an ASG425.  Memory usage was running around 30% before the firmware upgrade. Now, in about 18 hours it will go to 100%, swap will climb and CPU utilization will also hit 100%. Snort and HTTP proxy continue to restart


    This morning they did acknowledge a memory leak issue in 9.108!
    Below is a response:

    We have identified a memory leak in version 9.108 and have therefore released a patch in the form of 9.109 to address this.

    As the update was only released this morning it is still in "Soft release" and will not show in the WebAdmin of the UTM. You can however manually download the update and upload this to the WebAdmin of the UTM before applying it.


    I have applied the patch and will see if that resolves the issue
  • 0 in reply to bbryant_sma
    I ran into this two on two UTM 220's.  Extremely high SWAP usage.  Just upgraded the one and about to upgrade the other.  The other UTM 220 that is running 9.107 is running just fine.