This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

UTM HE not connecting to Router

I am a Noobie and I have just installed UTM 9 for use in home.
I want only to use the web proxy so have only one nic - which I am told is a config I can use in as a web proxy in "one arm mode".

Problem is that I cannot get the router to recognise the UTM.
Router is D-Link IP configured as 10.1.1.1.
Mask is 255.0.0.0

UTM
IP is 192.168.2.100
Mask is 255.255.255.0

What do I need to do to get these two talking... network lights on nic are red and amber.

Did note in the install log that the entry "127.0.0.1 refused connection" or similar occurred during install.

Cheers

This thread was automatically locked due to age.

Parents

0 WeePecky over 11 years ago

Thanks all, I have the web admn now up and running. I was thinking I had the IP's and subdomains screwed up but could not figure out why... working now.
I have an old PC with only one NIC, hence the reason for using as a web proxy only.
The advice I have from a proper techie type chap is that the proxy will work in "one arme" mode, that is with only one NIC. This is proving to be a second learning for me.

My cofiguration looks something like this:

wireless dsl router ISP
sophos proxy dsl router (same router as above

Such fun!
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 WeePecky over 11 years ago

Thanks all, I have the web admn now up and running. I was thinking I had the IP's and subdomains screwed up but could not figure out why... working now.
I have an old PC with only one NIC, hence the reason for using as a web proxy only.
The advice I have from a proper techie type chap is that the proxy will work in "one arme" mode, that is with only one NIC. This is proving to be a second learning for me.

My cofiguration looks something like this:

wireless dsl router ISP
sophos proxy dsl router (same router as above

Such fun!
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data