This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Replacing ASG220 with UTM220

Greetings- I have a stable ASG220 (firmware version 7.513) install and recently purchased a new UTM220 (version 9.105 2gb ram 1gb swap).

[Just fired up the UTM220 – boy are the two little fans loud!]

I have done the initial setup when a new unit is first started and have access to the dashboard now . . .

I’m asking for some guidance on how to best make the transition. I hope to be able to exchange out the old unit and just move my current configuration and settings to the new device. Any pitfalls to steer clear of or instructions would be much appreciated.

TIA

This thread was automatically locked due to age.

Parents

0 FrankDi Pasquale over 11 years ago

Thanks for the replies - I tried to import a backup from the ASG220 but it seemed to have stalled and after about 30 min, I had to power down. I will try the ISO option next and report the results.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 FrankDi Pasquale over 11 years ago

Thanks for the replies - I tried to import a backup from the ASG220 but it seemed to have stalled and after about 30 min, I had to power down. I will try the ISO option next and report the results.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data