Hi Everyone, there seems to be a bit of this going around not isolated to XenServer but this is the environment I'm trying to get the installation working in. I'm trying to evaluate Sophos UTM on XenServer. XenServer 6.02 Other Template for the Installation Mounting ISO virtual DVD drive When the system boots I receive the following error:- [ 0.076000] drivers/rtc/htctosys.c: unable to open rtcdevice (rtc0) INIT version 2.86 booting Then nothing further happens. Any ideas to get this working. I swear I"ve done this in the past with an older version without issue.

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

XenServer UTM 9.1 Install Fail: drivers/rtc/hctosys.c

Hi Everyone, there seems to be a bit of this going around not isolated to XenServer but this is the environment I'm trying to get the installation working in. I'm trying to evaluate Sophos UTM on XenServer.

When the system boots I receive the following error:-

[ 0.076000] drivers/rtc/htctosys.c: unable to open rtcdevice (rtc0)
INIT version 2.86 booting

Then nothing further happens. Any ideas to get this working. I swear I"ve done this in the past with an older version without issue.

This thread was automatically locked due to age.

0 scrantic over 11 years ago

Seriously anyone? Would be awesome to get this tested.
Cancel
Vote Up 0 Vote Down

Cancel
0 NathanCole over 11 years ago in reply to scrantic

I haven't played with Xen in a while... I have considered going back to them, now that they've gone open source.

It looks like it's hanging on INIT.

I had this issue when the ISO I downloaded was corrupted. I downloaded the ISO again, and it booted past INIT.
Cancel
Vote Up 0 Vote Down

Cancel