This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Migrating from 525 rev.4 to rev.5 hardware

Hi All,

I was lucky enough to recently take delivery of a new Sophos branded UTM-525 cluster.

These are replacing a current ASG-525 cluster running on Rev.4 hardware.

I am hoping to do an in place HA upgrade by adding the new UTM-525 boxes to the cluster, syncing, failing-over and then decommissioning the old ASG boxes.

Has anyone had experience with this or know if it is supported? All 525s are running 9.104-17 FW. There are approximately 10 RED tunnels and 15 AP30s attached also.

Appreciate any input.

Cheers,
MB

This thread was automatically locked due to age.

Parents

0 TheDrew over 12 years ago

Hi Mattrus,

The process you describe is basically how we do it on the lower end units, 120's in my case, so I'd expect the process is the same for all models.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 TheDrew over 12 years ago

Hi Mattrus,

The process you describe is basically how we do it on the lower end units, 120's in my case, so I'd expect the process is the same for all models.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data