This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

upgrade V7 to V8 ASG110

Hi all 

I have an ASG110 which has to be ugraded to V8 and later to V9 

ugrade fails without message via Web Interface

and also fails via CD 

I had a look in console mode after failure and noticed that the pre_install process fails as it doesnt detect ASG hardware .......

I'm really confused as this device is a real ASG110 appliance ... 
and it seems that some appliance specific HW 'tag/signature' is invalid ....

thanks for your help ....

Mathieu


This thread was automatically locked due to age.
Parents
  • For ASG220 rev.4 UTM v9 is supported but not recommended as can be read here

    If you don't have an USB CD/DVD-ROM or ASI/SUSI USB stick, you have to go the v7->v8->v9 U2pDate upgrade route. This will take some time and it's not possible to do this in one step.

    If you have, though, you could simply create a config backup, download the current v9.101 SSI ISO and install using the stick or USB CD/DVD-ROM, then apply the previously created config backup. When re-imaging using the ISO, you'll loose all existing reporting data. That way is a LOT faster in your case.
Reply
  • For ASG220 rev.4 UTM v9 is supported but not recommended as can be read here

    If you don't have an USB CD/DVD-ROM or ASI/SUSI USB stick, you have to go the v7->v8->v9 U2pDate upgrade route. This will take some time and it's not possible to do this in one step.

    If you have, though, you could simply create a config backup, download the current v9.101 SSI ISO and install using the stick or USB CD/DVD-ROM, then apply the previously created config backup. When re-imaging using the ISO, you'll loose all existing reporting data. That way is a LOT faster in your case.
Children
No Data