This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ASG220Rev No function after exchanging mainboard

Hi,

first of all: I use my ASG220 at home with a home license

My Rev4 is broken, it's my fault.
I bought a used Rev4 und plugged in the harddisk of the old one.

It boots perfectly und shows no erros on the console.
But it doesn't answer any ping nor arp on any interface.
The display shows the correct (old) IP-addresses.

With a 9.1 freshly installed it works perfect.

Do I have two user a new installation?
Can I copy last configuration backup onto the new installation?

Or is there any chance to join the old hard disk with the new mainboard?
(I'd prefer this)

Best regards
Xavier

This thread was automatically locked due to age.

Parents

0 stealthmatt_01 over 12 years ago

Hi there - I recently changed over from a custom built UTM to a Sophos UTM 220 and I found that for whatever reason when I imported the back up - it decided to select the first LAN port as the WAN IP.

If you plug a monitor in your UTM when it starts up it should say connect to web adming via https://***.***.***.***

If this is your internet IP then you will need to change your computer settings to match an ip in that subnet to connect... you can then assign the interfaces correctly once in.

Good luck
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 stealthmatt_01 over 12 years ago

Hi there - I recently changed over from a custom built UTM to a Sophos UTM 220 and I found that for whatever reason when I imported the back up - it decided to select the first LAN port as the WAN IP.

If you plug a monitor in your UTM when it starts up it should say connect to web adming via https://***.***.***.***

If this is your internet IP then you will need to change your computer settings to match an ip in that subnet to connect... you can then assign the interfaces correctly once in.

Good luck
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data