Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 14 replies
  • Subscribers 2 subscribers
  • Views 3269 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ASG 220 factory reset and upgrade from V6

oakers
Hi,

I have an ASG220 and want to factory reset the device, log in and then upgrade it to a later version of the required software. The admin password is unknown and thus the reason for the reset!

When I go through the factory reset on the front panel I get ten beeps from the device. At this point it seems to hang and I am unable to access the device.

I tried logging a support ticket but was told I needed to upgrade as V6 is no longer supported.

Anyone got any ideas?


This thread was automatically locked due to age.
Parents
  • 0
    Indeed, hardware becomes obsolete.

    Luckily though, you can use your own hardware and run the UTM software on that for a heck of a lot cheaper if you like the feature set Astaro offers.  This is what I do at home.

    Anything >2GB RAM should be fine all the way up to UTM9.1.
Reply
  • 0
    Indeed, hardware becomes obsolete.

    Luckily though, you can use your own hardware and run the UTM software on that for a heck of a lot cheaper if you like the feature set Astaro offers.  This is what I do at home.

    Anything >2GB RAM should be fine all the way up to UTM9.1.
Children
No Data
Cookie Information Banner