This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Clustered 320s v8 to v9 upgrade

Anyone out there running clustered appliances and has run through the up2date to get them from v8 to current version of v9? I have a couple of issues that I would like to get resolved that are supposed to be fixed in the newest version, but am a little hesitant to upgrade my remote site since I'm not there and my primary site due to service outages. 
If you had some experience with it, good or bad, I'd greatly appreciate some feedback.

Thanks,
James

UTM issues needing resolution;
1. PCRE limits exceeded in WAF while accessing OWA 2010 (some users. Not OS or location specific)
2. Dynamic routing (BGP) while using IPSec connections. (Not possible in v8)


This thread was automatically locked due to age.
Parents
  • I have done a few 9 upgrades.. no issues so far. None have been clustered though.
  • Thanks for taking the time to post. So far I've just reimaged my stand-alone 120s, but they haven't been my primary internet gateways. I might just go that route again, but I'm waiting for confirmation on whether or not active\active clustering is supported on the newest version of v9.

    Also, any easy way of comparing config files between the two once I break the cluster and upgrade one of them?

    Anyone else confirm that? V9 running clustered?
Reply
  • Thanks for taking the time to post. So far I've just reimaged my stand-alone 120s, but they haven't been my primary internet gateways. I might just go that route again, but I'm waiting for confirmation on whether or not active\active clustering is supported on the newest version of v9.

    Also, any easy way of comparing config files between the two once I break the cluster and upgrade one of them?

    Anyone else confirm that? V9 running clustered?
Children
No Data