This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

licencing ipv6 double counting

Hello,

Today got an alert, about reaching 90% of licence on my home use 50 user. I looked at the IP tab and see a whole bunch of IPv6 addresses which belong to same machines as the regular IPv4 addresses, also I think windows uses 2 IPv6 addresses. I have a IPv6 tunnel to he with a /48 subnet. 

Question is shouldn't those be counted as same user ? Because going like this I'll need a 100 user licence.


This thread was automatically locked due to age.
Parents
  • So today I got the notification that I ran out of IPs, I logged in and it says 88 are used. There are a huge amount of IPv6 addresses, I`m pretty sure they are no reseting.

    I logged in and did a "ip -6 neighbor show" and there are only like 10 addresses there while licensing shows over 60 addresses !!!! 

    First how can I check that they are reseting second how can I manually clear the table ? 

    This is starting to get out of hand [:(] and I`m considering to move the IPv6 tunnel behind the firewall again, but this is such a convenience and theoretically the IPv6 and v4 addresses are from the same host so should not double count !
Reply
  • So today I got the notification that I ran out of IPs, I logged in and it says 88 are used. There are a huge amount of IPv6 addresses, I`m pretty sure they are no reseting.

    I logged in and did a "ip -6 neighbor show" and there are only like 10 addresses there while licensing shows over 60 addresses !!!! 

    First how can I check that they are reseting second how can I manually clear the table ? 

    This is starting to get out of hand [:(] and I`m considering to move the IPv6 tunnel behind the firewall again, but this is such a convenience and theoretically the IPv6 and v4 addresses are from the same host so should not double count !
Children
No Data