This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Where to place Astaro appliance 320 on the network

Hi,
I have to put 'Astaro Appliance 320' on my network so that it can see traffic incoming for my 2 locations, which location is the best suited and where? Please point, I am enclosing a view of my network. Also how/where to make config change in Astaro so that its firewall opens up my internet connection.
Thanks
net diagram attached.

This thread was automatically locked due to age.

astaro support diagram.zip

Parents

0 William Warren over 14 years ago

for location 1 put the astaro after the 2911 via a cable from the 2911 to the asg. on location 2 put the astaro between the 2960 and the isp via a cable to another port on the asg. after you do that run the wizard and you should be up and running in a basic configuration. If you have nay troubles hit the documents online, post here, or contact a partner.

Owner: Emmanuel Technology Consulting

http://etc-md.com

Former Sophos SG(Astaro) advocate/researcher/Silver Partner

PfSense w/Suricata, ntopng,

Other addons to follow
Cancel
Vote Up 0 Vote Down

Cancel
0 amanzoor over 14 years ago in reply to William Warren

for location 1 put the astaro after the 2911 via a cable from the 2911 to the asg. on location 2 put the astaro between the 2960 and the isp via a cable to another port on the asg. after you do that run the wizard and you should be up and running in a basic configuration. If you have nay troubles hit the documents online, post here, or contact a partner.

Thanks William:
It means I need two astaro appliance 320? correct? ALso On location 1, the ethernet coming out of my router 2911 would go into the WAN port of Astaro? and from Astaros LAN port I will connect my Cisco switch 2960?. On location 2, the cable coming from my ISP would go into the WAN port of the Astaro? and from the LAN port of the Astoro to my switch 2960?
THanks
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 amanzoor over 14 years ago in reply to William Warren

for location 1 put the astaro after the 2911 via a cable from the 2911 to the asg. on location 2 put the astaro between the 2960 and the isp via a cable to another port on the asg. after you do that run the wizard and you should be up and running in a basic configuration. If you have nay troubles hit the documents online, post here, or contact a partner.

Thanks William:
It means I need two astaro appliance 320? correct? ALso On location 1, the ethernet coming out of my router 2911 would go into the WAN port of Astaro? and from Astaros LAN port I will connect my Cisco switch 2960?. On location 2, the cable coming from my ISP would go into the WAN port of the Astaro? and from the LAN port of the Astoro to my switch 2960?
THanks
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data