This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Update and Now WebAdmin not Work

Hi, When reboot the ASG show use the Public IP to access the webadmin but I can't because that link is down. Who change the webadmin to another eth to use the Local IP?

Regards


This thread was automatically locked due to age.
Parents
  •  I think only the networks list for webadmin as been modified. It's possible fix that?
    You can check the list of allowed networks in WebAdmin>>Management>>WebAdmin Settings.  I've never seen this spontaneously change though, so I would guess that your interfaces have changed the NICs that they are bound to due to the update.  In the interfaces section of WebAdmin, click on the Hardware Tab and verify that each NIC is assigned the "correct" eth number.  If not, you can follow Goldy's instructions or I can tell you how to do this in the filesystem (using SSH or SCP).
    __________________
    ACE v8/SCA v9.3

    ...still have a v5 install disk in a box somewhere.

    http://xkcd.com
    http://www.tedgoff.com/mb
    http://www.projectcartoon.com/cartoon/1
Reply
  •  I think only the networks list for webadmin as been modified. It's possible fix that?
    You can check the list of allowed networks in WebAdmin>>Management>>WebAdmin Settings.  I've never seen this spontaneously change though, so I would guess that your interfaces have changed the NICs that they are bound to due to the update.  In the interfaces section of WebAdmin, click on the Hardware Tab and verify that each NIC is assigned the "correct" eth number.  If not, you can follow Goldy's instructions or I can tell you how to do this in the filesystem (using SSH or SCP).
    __________________
    ACE v8/SCA v9.3

    ...still have a v5 install disk in a box somewhere.

    http://xkcd.com
    http://www.tedgoff.com/mb
    http://www.projectcartoon.com/cartoon/1
Children
No Data