This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

settting up a new internal network

deale2010 over 14 years ago

I want to have two different networks on two separate interfaces going out the same wan interface.
Ether 0 internal: 192.168.3.1
Ether 1 external: ***.***.***.***
Ether 2 internal: 192.168.1.1
I already have an IPSec site to site VPN connection established on Ether 0 Internal now I want to configure ether 2 internal go out the ether 1 external to the internet not the VPN and I do not want any of the internal traffic to be able to cross between them self’s .
All the internet traffic from ether 0 goes through the tunnel.
can some give me instuctions on how to config this scenario

This thread was automatically locked due to age.

0 BAlfson over 14 years ago

Hi, deal2010, and welcome to the User BB!

Let me say that in my own words to be sure I understand. You want both of your internal networks to be able to communicate via VPN to another network. In addition, you want all internet traffic for 192.168.3.0/24 to go the the internet via the VPN to the other site. Correct?

To do this, you need two tunnels:

Local networks: {192.168.3.0/24}
Remote Networks: "Internet" and whatever network there your eth0 network should be able to communicae with

Local networks: {192.168.1.0/24}
Remote netwrks: whatever network there your eth1 network should be able to communicae with

The configuration at the other site should mirror this.

Was that what you were looking for?

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel