This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ASG220 Vs Dell R610 Dedicated Server

Hi, we currently have an ASG220 unit but the performance is pretty poor. Without the unit, the internet is very speedy with pages loading instantly. With the unit however it takes a few seconds to load each page. 

I have since read that its possible to load the CFF into memory which we did, this sped things up straight away. Not as quick as without the unit but a definite improvement. The issue now is that the unit only has 1GB of ram so alot of information is being paged slowing the unit down overall. The only solution i can think of is to dump the ASG unit and go with a dedicated server.

I have a server which is a Dell R610, has a 2.26ghz quad core processor and 8GB of RAM, obviously a massive improvement over the ASG unit.

The question is this, is it worth changing over from the ASG unit to a dedicated server. Has anyone done this themselves and was there massive gains in performance?

Thanks
Chris


This thread was automatically locked due to age.
  • The Dell is a massive upgrade in hardware so you should see great speed increases.  You will have to change your licensing however and need to evaluate the cost of doing so.
  • Hi, you should run the CFF db from DISK instead of from RAM to avoid swapping of other processes; how do you have it set?

    Barry
  • Hi, you should run the CFF db from DISK instead of from RAM to avoid swapping of other processes; how do you have it set?

    Barry


    Hi Barry, we currently have it set to RAM. Because of the RAM restriction on this unit we did try DISK to begin with but didnt notice a decent improvement in page load times so switched it to load into RAM which improved performance greatly.

    Thanks
    Chris
  • Well, Astaro doesn't recommend running the CFF db from ram with only 1GB.

    As far as your original question, you should talk to your reseller about converting your license to the 'software' version, or upgrading to a more capable appliance.

    I wouldn't expect "massive gains in performance" unless your system is swapping so badly as to make it unusable, or your CPU is overloaded already.

    Barry