This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Installation issue

Hi All, trying to install the latest ASG8 on an HP machine. It has an onboard NIC, and we have added 2 Dlink nics. For some reason, it detects all 3 (regardless of bios settings) and will even show link on any of the 3 during installation. But - when it boots for the first time, the link light goes OUT during boot and will not come back on - this appears to be only on the nic set to be the admin interface.

Because of this issue I am not able to get into the admin interface and look into the issue any further...

Any ideas?

This thread was automatically locked due to age.

0 BrucekConvergent over 14 years ago

If the NIC in question is not on the HCL, try a different NIC. If you are using Version 7, give the Version 8 ISO a shot, it works with more hardware than V7 did.

CTO, Convergent Information Security Solutions, LLC

https://www.convergesecurity.com

Advice given as posted on this forum does not construe a support relationship or other relationship with Convergent Information Security Solutions, LLC or its subsidiaries. Use the advice given at your own risk.
Cancel
Vote Up 0 Vote Down

Cancel
0 BarryG over 14 years ago

Hi, which HP model?

Barry
Cancel
Vote Up 0 Vote Down

Cancel