This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Astaro 8.002 constant dhcpd restart

I'm setting up a new PC with Astaro 8.002 for my home network and it runs fine for a couple minutes but then the dhcpd keeps restarting.  I've watched it in the live log and I don't see any error messages; it just goes through what looks like a boot-up process and then says "exit".  I saw another post on something like this but it sounds like his solution isn't relevant for my situation and I don't think the other posters thought it was actually what solved the problem.

I've reinstalled the OS a couple times.  I get Internet connectivity through the Astaro as long as I self assign IPs.

Listed below is the e-mail it sends me:

Dhcp daemon not running - restarted

--
System Uptime : 0 days 1 hours 10 minutes
System Load : 0.63
System Version : Astaro Security Gateway Software 8.002

Please refer to the manual for detailed instructions.

-----------------------

It's a home install so I don't have a manual.  Can anyone help?

Thanks so much.

This thread was automatically locked due to age.

Parents

0 Nimble7 over 15 years ago

Hi Bob. Thanks for responding. I downloaded the manual and did a keyword search on "dhcp". While the manual does a nice job of explaining setup, I didn't see much on troubleshooting and I didn't see anything on this error. I've tried complete reinstalls and I've used different NICs on each install as my management interface.

This is a replacement for my previous 7.x home pc ASG. That PC died. Since this is both a new ASG version and a PC I don't have much of a way to identify whether it's a software or hardware issue. I looked through some of the logs but I don't really know what I'm looking for. Nothing really jumped out. The dhcpd live log didn't give an explanation of why it was exiting.

Any thoughts or tips are appreciated.

Thanks!
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Nimble7 over 15 years ago

Hi Bob. Thanks for responding. I downloaded the manual and did a keyword search on "dhcp". While the manual does a nice job of explaining setup, I didn't see much on troubleshooting and I didn't see anything on this error. I've tried complete reinstalls and I've used different NICs on each install as my management interface.

This is a replacement for my previous 7.x home pc ASG. That PC died. Since this is both a new ASG version and a PC I don't have much of a way to identify whether it's a software or hardware issue. I looked through some of the logs but I don't really know what I'm looking for. Nothing really jumped out. The dhcpd live log didn't give an explanation of why it was exiting.

Any thoughts or tips are appreciated.

Thanks!
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data