This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Rack Mounting ASG220 Hardware

Hello,

I have an ASG220 (1U) that I would like to rack mount. However, I'm not too sure how to go about this. I have the front mounting brackets that came with it, but I'm pretty sure that isn't enough to support the whole unit. Do I need to buy a specific set of rails or will any 1U rails work?

Thanks. [:)]

This thread was automatically locked due to age.

Parents

0 BAlfson over 15 years ago

Lane, it works OK, but I'd make sure that the power cable is connected in such a way that someone pulling on the cable lifts the back instead of pulling it down. I agree that Astaro should have the case drilled to accept "real" rails or some way to support the rear of this long 1U box.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BAlfson over 15 years ago

Lane, it works OK, but I'd make sure that the power cable is connected in such a way that someone pulling on the cable lifts the back instead of pulling it down. I agree that Astaro should have the case drilled to accept "real" rails or some way to support the rear of this long 1U box.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data