This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

I Can see 2 of 4 eth interface on WEBadmin

Hello,
I install Astaro V8 Home Edition on a ACrosser Motherbord with 4 ethernet port. When I install and on the Support->Advanced->Interfaces Table, I Can see all 4 interfaces. But When I try to create in a new Interface, my hardware selection on show eth0 and eth3. Does anyone have any idea about what is wrong with my configuration.

This thread was automatically locked due to age.

Parents

0 BAlfson over 15 years ago

What do you see on the 'Interfaces Table' tab of 'Support >> Advanced'?

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BAlfson over 15 years ago

What do you see on the 'Interfaces Table' tab of 'Support >> Advanced'?

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 khaphan over 15 years ago in reply to BAlfson

Hi, Bob
I have all my 4 ethernet port on Interfaces Table :
[ATTACH]4499[/ATTACH]

Thanks for you Help,

Khang
What do you see on the 'Interfaces Table' tab of 'Support >> Advanced'?

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel