This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

I Can see 2 of 4 eth interface on WEBadmin

Hello,
I install Astaro V8 Home Edition on a ACrosser Motherbord with 4 ethernet port. When I install and on the Support->Advanced->Interfaces Table, I Can see all 4 interfaces. But When I try to create in a new Interface, my hardware selection on show eth0 and eth3. Does anyone have any idea about what is wrong with my configuration.

This thread was automatically locked due to age.

0 BarryG over 15 years ago

Hi,
When you are creating a new interface, it should only list interfaces not already in use, so I'm not sure that there's a problem.

Can you post screenshots?

Barry
Cancel
Vote Up 0 Vote Down

Cancel
0 khaphan over 15 years ago in reply to BarryG

I only use 2 of 4 interfaces (1 for LAN and 1 for WAN).
Here is my Interfaces Table ScreenShot
[ATTACH]4494[/ATTACH]
And As you can see on the screenshot below, I can not use eth1 or eth2 when adding a new interface.

[ATTACH]4495[/ATTACH]
Hi,
When you are creating a new interface, it should only list interfaces not already in use, so I'm not sure that there's a problem.

Can you post screenshots?

Barry
Cancel
Vote Up 0 Vote Down

Cancel
0 BAlfson over 15 years ago

What do you see on the 'Interfaces Table' tab of 'Support >> Advanced'?

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel
0 BarryG over 15 years ago

Hi Bob, it looks like that's what's in the first screen shot.

Barry
Cancel
Vote Up 0 Vote Down

Cancel
0 khaphan over 15 years ago in reply to BAlfson

Hi, Bob
I have all my 4 ethernet port on Interfaces Table :
[ATTACH]4499[/ATTACH]

Thanks for you Help,

Khang
What do you see on the 'Interfaces Table' tab of 'Support >> Advanced'?

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel