This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Change IP of Interface

Hi
I tried to change the IP address of one of my NIC interfaces, but registered that the NIC definitions didn't update. So I had to delete the interface in question and define it over again but with the correct IP. Is this normal behavior?

/Andy

This thread was automatically locked due to age.

0 BAlfson over 15 years ago

I tried to change the IP address of one of my NIC interfaces, but registered that the NIC definitions didn't update

I'm a little confused that you say you tried to change the IP on one interface, but that "the NIC definitions didn't update." This normally works just fine. If you tried to assign the same IP to two different interfaces, that should have given you an error message of some sort instead of just ignoring your instructions; in my book, that would be a bug.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel
0 Joffer over 15 years ago

Perhaps he changed it from console with ipconfig?
Cancel
Vote Up 0 Vote Down

Cancel