This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ASG220: Does not power down

Hi folks,
i've got a strange behavior with a brand new asg 220.

I've copied the config of a runnig asg and restored on the new device. Everything is fine.

So i shuted down the box and it is only beeping. On the screen it show the following:
http://img197.imageshack.us/img197/6127/errorastaro.jpg

It looks like a service could not be ended while swichting to runlevel 0.

I've never had such a issue before. is there a solution?

The actual firmware is 7.501. (we need this box with 7.501 for two weeks). After that it will be new installed and running with 7.504

Best Regards
Marco

This thread was automatically locked due to age.

Parents

0 r2k over 15 years ago

Hi William,

well yes this would be the best solution. But: I've copied the config of a running asg (also version 7.501) to this box. I need this for a upgrade next week --> productiv box will be replaced by the "new one" --> update on the productiv box --> when it is ok --> change back to the old box. The customer has decided to not buy a cluster, so we have to do this like that...

After this i will reinstall the new box and update to 7.504 and configured it from scratch for the new enviroment.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 r2k over 15 years ago

Hi William,

well yes this would be the best solution. But: I've copied the config of a running asg (also version 7.501) to this box. I need this for a upgrade next week --> productiv box will be replaced by the "new one" --> update on the productiv box --> when it is ok --> change back to the old box. The customer has decided to not buy a cluster, so we have to do this like that...

After this i will reinstall the new box and update to 7.504 and configured it from scratch for the new enviroment.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data