This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Multiple WAN Interfaces

Hi, i'm running Astaro 7.504 with 8 interfaces.
- 4 interfaces contain internal networks.
- 4 interfaces (should) go to the (same) external network.
When i setup the second external interface, it doesn't allow me to hand him the gateway, as the same gateway is already set as default gateway on the first external interface. When I add it without gateway it's fine and can be activated, but isn't available in the network.

Why I want this:
project 1-4, have sometimes one ore multiple servers that shall have an own network. they create lots of traffic, that's why I want to give each project one external interface / 1Gbit connection.

a gordian knot for me - anyone can strike it?

This thread was automatically locked due to age.

Parents

0 mckarto over 15 years ago

Thanx a lot for all responses.
The ASL7 is installed on Fujitsu RX300 system with 3GB RAM and yes 4 times 1GBit connections. The servers generate high traffic (geodata transfers) with little ports open. The hint of configuring IPS specially on them might be really a good one.
I'll also try the balancing / link aggregation and will report when I've got test results. Even though I actually really want to guarantee 1 GBit per server it might be better not to use it.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 mckarto over 15 years ago

Thanx a lot for all responses.
The ASL7 is installed on Fujitsu RX300 system with 3GB RAM and yes 4 times 1GBit connections. The servers generate high traffic (geodata transfers) with little ports open. The hint of configuring IPS specially on them might be really a good one.
I'll also try the balancing / link aggregation and will report when I've got test results. Even though I actually really want to guarantee 1 GBit per server it might be better not to use it.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data