This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

installation problem at DL 380 G6

Dear All,

I have problem to install astaro at DL 380 G6,
when I install this server alway error in the step 3 of 7
"Installation failed " Please remove CD-ROM and restart The System.

I Use 2 CD installation ASG V 7.2 and ASG V7.3, problem still same,

did Server DL 380 G6 don't support Or My CD problem?

I read HCL the latest server support just until DL380G5

This thread was automatically locked due to age.

Parents

0 KSeemann over 15 years ago

I have a DL360G6... and the CD/DVD issue was the only one i had so far...

If i remember correctly it was a Chipset Problem. So i used a "Astaro Smart Installer" USB Stick, that emulates a CD-Rom. A "real" USB CD/DVD-Drive would work too.

If you get an ASI-Stick, remember that it is preinstalled with an Hardware-Appliance only Version of Astaro. But you can download the ASI Image for the Software-Appliance from Index of /Astaro_Security_Gateway/v7/software_appliance/smart_installer.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 KSeemann over 15 years ago

I have a DL360G6... and the CD/DVD issue was the only one i had so far...

If i remember correctly it was a Chipset Problem. So i used a "Astaro Smart Installer" USB Stick, that emulates a CD-Rom. A "real" USB CD/DVD-Drive would work too.

If you get an ASI-Stick, remember that it is preinstalled with an Hardware-Appliance only Version of Astaro. But you can download the ASI Image for the Software-Appliance from Index of /Astaro_Security_Gateway/v7/software_appliance/smart_installer.
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 ghufron over 15 years ago in reply to KSeemann

thanks for response,

but if I see from its error logs there is information hard drive problems,

This error file his

Alt F3: "Report Log"
------------------------------------------
Total 8 CPU(s) found
Installer is is running as Vmware Guest
Searching for storage controllers
Storage controller : Hewlett-Packard Company IDE interface
Storage controller : Hewlett-Packard Company RAID bus controller
Total 2 storage controller found
Searching for disks
Total 0 disks found
PHASE END: hw_conf (ret=0
umount: /dest//sys: No such file or directory
umount: /dest//proc: No such file or directory
umount: /dest//boot: No such file or directory
umount: /dest//opt/inst: No such file or directory
umount: /dest//var/storage: No such file or directory
umount: /dest//var/log: No such file or directory
umount: /dest//tmp: No such file or directory
umount: /dest//: Invalid argument
------------------------------------------
Cancel
Vote Up 0 Vote Down

Cancel
0 BarryG over 15 years ago in reply to ghufron

Hi, which RAID controller are you using, and have you setup the RAID already?
I believe at least the p400i controllers are supported.

Barry
Cancel
Vote Up 0 Vote Down

Cancel