This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Proper setup for external administration

I have an ASG install that I need to manage remotely, yet I am unable to access the WebAdmin from anywhere other than on the end user's LAN.

What is the proper way to setup the Administration Interface during the initial install that will allow this?

This thread was automatically locked due to age.

Parents

0 BarryG over 16 years ago

Hi, you can add any networks you need, in the Administration section of webadmin.

Barry
Cancel
Vote Up 0 Vote Down

Cancel
0 jcargile over 16 years ago in reply to BarryG

I have added the "External (WAN)" yet still connot access the WebAdmin except from inside the user's network.

There are no "Drops" in the Packet Filter Log.
Cancel
Vote Up 0 Vote Down

Cancel
0 BarryG over 16 years ago in reply to jcargile

External WAN is the local subnet between the firewall and ISP.

Try ANY or Internet.

Barry
Cancel
Vote Up 0 Vote Down

Cancel
0 jcargile over 16 years ago in reply to BarryG

Tried both ANY and Internet but still cannot gain access.

I use "WebSite Pulse" to test external access with my domain name and Public IP address over HTTPS port 4444. The connection just times out.
Cancel
Vote Up 0 Vote Down

Cancel
0 jcargile over 16 years ago in reply to jcargile

Figured it out!!!!!!
My ISP blocks Port 4444 along with 443.
Cancel
Vote Up 0 Vote Down

Cancel
0 BrucekConvergent over 16 years ago in reply to jcargile

I was gonna say change the default port... port 4444 is blocked by a few ISPs, apparently it was / is commonly used by a worm.

CTO, Convergent Information Security Solutions, LLC

https://www.convergesecurity.com

Advice given as posted on this forum does not construe a support relationship or other relationship with Convergent Information Security Solutions, LLC or its subsidiaries. Use the advice given at your own risk.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BrucekConvergent over 16 years ago in reply to jcargile

I was gonna say change the default port... port 4444 is blocked by a few ISPs, apparently it was / is commonly used by a worm.

CTO, Convergent Information Security Solutions, LLC

https://www.convergesecurity.com

Advice given as posted on this forum does not construe a support relationship or other relationship with Convergent Information Security Solutions, LLC or its subsidiaries. Use the advice given at your own risk.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data