This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

USB Network interface

Hi everyone!
As I am using a small "shuttle" pc which can only host 2 network-cards, I want to add a third usb-networkinterface (dlink- Dub-E100). Problem is: the device is not recognized. Nor with the running ASG 7.501 I'm using right now, neither at installation process...

Has anyone experience in running an usb-networkinterface?
i couldn't find the 'usbnet'-module , which is often used for these purposes...
Any idea would help!

jp

This thread was automatically locked due to age.

Parents

0 Gert Hansen over 16 years ago

Hi jp,

in order to configure a VLAN interface, you need to make sure that no other interface is configured there. this means you need to delete the existing interface on that EthernetDevice than create two VLAN interfaces with the appropriate tags and than you need to configure your VLAN capable switch that these two VLANs come in that port, where this Ethernet Device is connected to the switch.

I hope this helps,
regards
Gert
Cancel
Vote Up 0 Vote Down

Cancel
0 jpbaxter over 16 years ago in reply to Gert Hansen

Thanks Gert,
I've tried it and it worked just fine! Sometimes a solution can be so simple!There should be a hint in the adminguide, as I read the chapter on VLAN and it is not mentioned, that a "clean" interface is required...

Viele Grüße aus München,jp
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 jpbaxter over 16 years ago in reply to Gert Hansen

Thanks Gert,
I've tried it and it worked just fine! Sometimes a solution can be so simple!There should be a hint in the adminguide, as I read the chapter on VLAN and it is not mentioned, that a "clean" interface is required...

Viele Grüße aus München,jp
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data