This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Configuring WAN

Having a bit of trouble here. Seems as if our LAN is up and functioning but we can't get out to the net. External interface has correct IP and GW settings and i'm not sure whats causing it. Do i need to reboot the firewall and then the router to clear the MAC routing table from the router? We have an ASG 525 and a cisco router.

This thread was automatically locked due to age.

Parents

0 AngeloC over 16 years ago

Hi Joker,

Did you make a NAT rule and/or packet filter permissions as well?
Cancel
Vote Up 0 Vote Down

Cancel
0 joker5893 over 16 years ago in reply to AngeloC

Yeah i have NAT rules set up and packet filters. All have checked out though
Cancel
Vote Up 0 Vote Down

Cancel
0 Simon Shaw over 16 years ago in reply to joker5893

Why are you using both the cisco and Astaro?

Bit hard to help without more details on how the networks configured.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Simon Shaw over 16 years ago in reply to joker5893

Why are you using both the cisco and Astaro?

Bit hard to help without more details on how the networks configured.
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 joker5893 over 16 years ago in reply to Simon Shaw

Why are you using both the cisco and Astaro?

Bit hard to help without more details on how the networks configured.

The router is in place from our ISP. Their T1's connect to it. The router then goes to the firewall and then to the LAN
Cancel
Vote Up 0 Vote Down

Cancel