This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Stuck at Run Level

Just installed latest 7.4 & on reboot im getting as far as enter runlevel where it sits waiting for imput.

Ive tried both 3 & 5 without success.

Is this a normal part of startup now. What am i meant to be entering?

Regards

Andrew

This thread was automatically locked due to age.

Parents

0 RFCat_vk_01 over 16 years ago

Hi Andrew,
you aren't meant to enter anything during the boot cycle. The stuck at runlevel possibly means a hardware fault or hardware incompatibility.
Have you had this version running on this hardware before?

Regards
Ian M
Cancel
Vote Up 0 Vote Down

Cancel
0 akennedy over 16 years ago in reply to RFCat_vk_01

Yes i have. I have had version 7 & up for awhile now. Just installed 7.4 on another hard drive & have hit this wall.
Cancel
Vote Up 0 Vote Down

Cancel
0 RFCat_vk_01 over 16 years ago in reply to akennedy

Hi,
different type of harddrive eg SATA instead of IDE?

Ian M
Cancel
Vote Up 0 Vote Down

Cancel
0 akennedy over 16 years ago in reply to RFCat_vk_01

Same model PC. Just took original hard drive out & replaced with exactly the same from other unit. Nothing trickier than that
Cancel
Vote Up 0 Vote Down

Cancel
0 BAlfson over 16 years ago in reply to akennedy

Did you load Astaro onto the drive when it was in the other PC? This doesn't work very often.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel
0 akennedy over 16 years ago in reply to BAlfson

It was installed on the new 'fresh' hard drive after replacing other harddrive with had earlier version on ASG installed on it (7.3)

PC being used is an IBM think centre & it had previously worked fine on a repilica model. Problem was that the original PC's onboard graphic/video card became faulty & i had no room to slot in a replacement.

I had another one (PC of this type) available so i simply swapped out the 2 nics & am now stuck after install to different hard drive.

I tried installing the other ASG 7.3 hdd into replacement PC but i cannot get one of the nics to see internal LAN hence i cant get to webmin page.
Cancel
Vote Up 0 Vote Down

Cancel
0 BarryG over 16 years ago in reply to akennedy

Failing to boot could be caused by different LBA settings in the BIOS between the two computers.

Maybe a bad NIC?

Barry
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BarryG over 16 years ago in reply to akennedy

Failing to boot could be caused by different LBA settings in the BIOS between the two computers.

Maybe a bad NIC?

Barry
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data