Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 2 replies
  • Subscribers 2 subscribers
  • Views 732 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

switch

utm_kid
Hi !

today i connected my 1st 110  ,(i have to connect 220 at clients place )it has 1 small page where it says/show diagram lan port has to be connected with switch, is it mandatory to connect  trough Ethernet switch because i try to connect directly after system boot my pc shows connect and after some time it say unplugged Ethernet cable  but afte putting cable trough switch it works fine !

is 220 has also same procedure !

Thanks


This thread was automatically locked due to age.
Parents
  • 0
    Although some Ethernet switches are auto-sensing, I don't know of any computers that can adapt to a direct connection.  It pays to have an Ethernet Crossover Cable in your toolkit.
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
  • 0 in reply to BAlfson
    Although some Ethernet switches are auto-sensing, I don't know of any computers that can adapt to a direct connection.  It pays to have an Ethernet Crossover Cable in your toolkit.


    ok !

    Thanks !
Reply Children
No Data
Cookie Information Banner