Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 3 replies
  • Subscribers 2 subscribers
  • Views 3125 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

add new ethernet interface in virtual ASG

Turbo
I am evaluating ASG 7.200 as virtual appliance on ESX 3.5. A third network interface has been added to the virtual machine but is not recognized by the ASG. I can only see eth0 and eth1. Is there anything else I need to do in order to activate eth2?

Regards
Dirk


This thread was automatically locked due to age.
Parents Reply Children
  • 0 in reply to RFCat_vk_01
    I just found that using ifconfig on the command line allows to set an ip address for eth2. However, this interface is still not available as hardware for a new interface in the ASG software. A reboot did the trick and now I can create a new network interface in WebAdmin.
  • 0 in reply to Turbo
    Yeah, with the VMWare image reinstallation is not required... a reboot is all that is needed.

    CTO, Convergent Information Security Solutions, LLC

    https://www.convergesecurity.com

    Advice given as posted on this forum does not construe a support relationship or other relationship with Convergent Information Security Solutions, LLC or its subsidiaries.  Use the advice given at your own risk.

Cookie Information Banner