This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

add new ethernet interface in virtual ASG

I am evaluating ASG 7.200 as virtual appliance on ESX 3.5. A third network interface has been added to the virtual machine but is not recognized by the ASG. I can only see eth0 and eth1. Is there anything else I need to do in order to activate eth2?

Regards
Dirk

This thread was automatically locked due to age.

0 RFCat_vk_01 over 17 years ago

Hi,
the only way that I am aware of is to re-install the ASG software.

Ian M
Cancel
Vote Up 0 Vote Down

Cancel
0 Turbo over 17 years ago in reply to RFCat_vk_01

I just found that using ifconfig on the command line allows to set an ip address for eth2. However, this interface is still not available as hardware for a new interface in the ASG software. A reboot did the trick and now I can create a new network interface in WebAdmin.
Cancel
Vote Up 0 Vote Down

Cancel
0 BrucekConvergent over 17 years ago in reply to Turbo

Yeah, with the VMWare image reinstallation is not required... a reboot is all that is needed.

CTO, Convergent Information Security Solutions, LLC

https://www.convergesecurity.com

Advice given as posted on this forum does not construe a support relationship or other relationship with Convergent Information Security Solutions, LLC or its subsidiaries. Use the advice given at your own risk.
Cancel
Vote Up 0 Vote Down

Cancel