This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

upgrade problems

I have a few questions.

1. We have an astaro 6 install. we want to upgrade to 7.  We are running it on a dell 1850 with a perc 4 raid controller and two 80 gig drive in raid 1.  We had a problem at first because the dell virtual cd rom drive ( drack card) was throwing the installer off.  So we disabled it and the installer still fails but we have no idea why.  Its a dual core dual chip xeon system with 2 gigs of ram.

We contacted astaro support a few times only to have a reply 8 hours later that it should work.  is there any special mode to start the install in so that it shows why it fails instead of just saying restart ?

2.  Our goal is to have 2 internet connections two firewalls each of which can switch to the next to make sure that we are totally covered when it comes to network outages and problems.  Can you point me to any (plain english) information on this.  Basically  firewall one handles our main internet , firewall two handles our backup internet, in the event internet one goes down firewall one routes all traffic through internet backup.  If backup internet goes down  firewall two routes its normal traffic through firewall one, and in the vent either firewalls goes down we have another nic on them to handle there traffic on the alternate firewall.  

It sounds complicated and it probably is, but i wasn't able to find a simple explanation on how to do high availability with two connections and two firewalls.

3.  If there is a better way to do number two please share.

Thank you for your time gentlmen.


This thread was automatically locked due to age.
  • Hello.

    1) During the installer, just hit alt+f2, f3, f4 for a console screen and various output screens regarding the installer. Should show you why it failed. do this after it says installation failed on the main screen (alt+f1) and you should be able to see why. Likely it is the raid controller or a NIC thats not supported, that should tell you absolutely.


    2) for your setup, what you should do is run both internet connections to each firewall, running in cluster (active/active) or ha (active/passive) so that way not only can each firewall "fail over" to the other internet connection when the main connection is dead, but the boxes themselves have full redundancy. This makes sense since then you do not have to failover firewalls just to accomodate a downed wan connection, since why not just fail to the other connection on the same box. So yes, what you want is possible. Combine this setup with link aggregation to redundant switches, and cable everything twice, and your quite bombproof.