This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ASL 6.311 freezes

Hello together,

We're using Astaro since Version 3 and we have the problem that the maschine freezes. It's not possible to enter the console neither to enter the wedamin-interface. First we thought that the harddisk are having some trouble and replaced them. We although checked if there's a temperature problem, but the temperature is ok.

This thread was automatically locked due to age.

0 BrucekConvergent over 18 years ago

Check the hardware reporting graphs... right before it dies, do you see a spike in load or ram usage? If so, you may be running an underpowered system.

CTO, Convergent Information Security Solutions, LLC

https://www.convergesecurity.com

Advice given as posted on this forum does not construe a support relationship or other relationship with Convergent Information Security Solutions, LLC or its subsidiaries. Use the advice given at your own risk.
Cancel
Vote Up 0 Vote Down

Cancel
0 PAG over 18 years ago in reply to BrucekConvergent

The hardware reporting graphs are not showing any peaks in load or ram usage. The system is a 2-way 1.2 Ghz Pentium and has 1 GB Ram, RAID-1 with 80 GB HDDs. Any other suggestions?
Cancel
Vote Up 0 Vote Down

Cancel
0 Jhaislet over 18 years ago in reply to PAG

Sounds like it might be a hardware issue since that's an older machine. Maybe try switching out the ram first or doing a re-install.
Cancel
Vote Up 0 Vote Down

Cancel
0 drees over 18 years ago in reply to Jhaislet

Yeah, the primary cause of lockups on 6.*** for us has been flaky hardware.

Try running memtest86 for at least 4 hours and preferably 12-24 hours if you can to rule out memory problems.

Luckily, it's fairly straight forward to swap in a temporary replacement as long as you can source a machine with the same number of nics if you need to avoid significant downtime.
Cancel
Vote Up 0 Vote Down

Cancel
0 PAG over 18 years ago in reply to drees

This could be the reason, but the system is running very well and there are now freezes, until our CRM dept. is sending a newsletter. Then we receive a lot of out-of-offices replies to our internal emailsystem in a short period of time and the system freezes.
Cancel
Vote Up 0 Vote Down

Cancel
0 Jhaislet over 18 years ago in reply to PAG

One reason why hardware goes bad/freezes:

http://en.wikipedia.org/wiki/Tin_whisker
Cancel
Vote Up 0 Vote Down

Cancel