This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

After Upgrade on V7.005 Astaro crashed

I have a great problem.
I've upgraded a ASG 220 to V7.005.
After the upgrade i can't access the webadmin..
No SHH runs. The only way to access the ASG is with a serial connect.

This ASG is for a testing area.
The eth0 is reachable with the IP 192.168.2.100. But no Webadmin.
I had make a factory reset but always the same problem.

What should i do now?

This thread was automatically locked due to age.

Parents

0 BrucekConvergent over 18 years ago

Have you tried reloading it again?

CTO, Convergent Information Security Solutions, LLC

https://www.convergesecurity.com

Advice given as posted on this forum does not construe a support relationship or other relationship with Convergent Information Security Solutions, LLC or its subsidiaries. Use the advice given at your own risk.
Cancel
Vote Up 0 Vote Down

Cancel
0 suzzyx over 18 years ago in reply to BrucekConvergent

I know it sounds stupid but are you sure that you are connecting to the webadmin via port 4444¿?

https://your.astaro.box.ip:4444

Greets.
Cancel
Vote Up 0 Vote Down

Cancel
0 epearson over 18 years ago in reply to suzzyx

I couldn't figure out what to do, had same problem, but usually go in directly via the IP, so appending the 4444, did the trick!
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 epearson over 18 years ago in reply to suzzyx

I couldn't figure out what to do, had same problem, but usually go in directly via the IP, so appending the 4444, did the trick!
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data