This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Unable to complete backend request ... after importing ASG 6 configuration

solved - show Post #7

Hi,

after importing a backup from ASG 6 to ASG 7.005 i am unable to login to ASG 7 ! ASG says to me: "Unable to complete backend request. Please click Shift-Reload in your browser to attempt re-login"

My ASG 6 configuartion was low level with no "special things". The same error came on VMware.

What can I do ?

best regards
michael

This thread was automatically locked due to age.

Parents

0 RFCat_vk_01 over 18 years ago

Same as in your other post. What versions of IE or firefox are you using?

Ian M
Cancel
Vote Up 0 Vote Down

Cancel
0 druide over 18 years ago in reply to RFCat_vk_01

same here. wait and wait for V6 import, and now ....
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 druide over 18 years ago in reply to RFCat_vk_01

same here. wait and wait for V6 import, and now ....
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 michaelxy over 18 years ago in reply to druide

Its not the browser. Using: MS IE6 or FF 2.04. A external login via the DSL-Interface does not work too.
Cancel
Vote Up 0 Vote Down

Cancel
0 Scott_Klassen over 18 years ago in reply to michaelxy

I saw the same thing in a test install of 7.005 in VMWare. I rebooted the virtual machine and closed my browser. Once the reboot completed, I reopened my browser, connected to the Astaro VM and logged in fine.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel
0 michaelxy over 18 years ago in reply to Scott_Klassen

I made x reboots but i can not log me in. The Problem was on vmware 1:1 the same.
Cancel
Vote Up 0 Vote Down

Cancel
0 michaelxy over 18 years ago in reply to michaelxy

Sodele - now I made a new backup with ALS 6.306 AND on:

System - WebAdmin Settings - Access and Authentication - Allowed Networks:
I delete other entries than "any". So that "any" has access to the WebAdmin Interface and not any other than "any" :-)

Now it works under vmware and i think it will work an real hardware
Cancel
Vote Up 0 Vote Down

Cancel