Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 4 replies
  • Subscribers 2 subscribers
  • Views 1696 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Additional IP-Address on Ethernet Interface

Andre Zirkenbach
Hello,

hope anyone can help me. I use Astaro v7.002 
Here what iam doing[:(] 

I setting up an additional address for eth3. Wait some time. After a refresh on Webadmin the address seems to be up.
Now i test a ping to the address, no answer. I test a ping to the address on eth3 - it is answering.

If i take a look on the console, with ifconfig, i see all my IPs, when a test a ping from the console to the additional IP-Address i get an answer.

Does anyone have the same problems with additional IPs??[:@] 

Thanks for your answer!
André


This thread was automatically locked due to age.
Parents
  • 0
    I'm new to Astaro so I may be way off base, but do you have to setup any packet filter rules to allow access to the new IP address? I know when I first setup my Astaro V7.002, there were some check boxes to allow ICMP and PING to and through the firewall, but I'm not sure if that would apply to additional IP addresses or not.
  • 0 in reply to junior15
    I have done so. I created some DNAT-Rules and some Packet Filter Rules, nothing works. Nothing on the additional address is responding.
Reply Children
Cookie Information Banner